WatchGuard Firebox X Edge e-Series devices with Fireware XTM (Fireware 11) are fully supported in current versions of VPN Tracker. For details please see our configuration guide.
Devices running an older firmware may often work using the following setup. Please note however that we can't guarantee that this setup will work in all cases.
Start by creating a new user on the Firebox Edge and then configure MUVPN support for this user.
In VPN Tracker, use a "Custom Connection" device profile as the basis for your new connection.
Map the WatchGuard settings to your VPN Tracker configuration as shown in the table below:
The following settings are independent of your specific MUVPN configuration:
Finally make sure the that VPN Tracker's "Network" setting is set to "Host to Network", and the correct Remote Network (i.e. the network that you want connect to through the VPN) is used (e.g. 192.168.1.0/255.255.255.0).
Your direct line to the equinux TARMAC team
Our TARMAC team is ready and waiting:
firstname.lastname@example.org or by Telephone +49 (0)89 / 520 465-222
You're interested in equinux products and have additional questions regarding your purchase or product activation?
The equinux Sales Team is here to help: Call or chat with us,
Cisco Small Busi ...
Kame (Free BSD, ...
Palo Alto Networ ...